The Murano was hesitating and lurching both at low speed and on the highway. We thought it was CVT related, but the check engine codes were related to the Va…
Cam Position Sensor Replacement – Nissan Murano 3.5L
49
Like
Save
){kind=link}
Comments
Write a comment
You must be logged in to post a comment.
I have no idea. I replace them both if one is acting up. The other won’t
be far behind.
Whay changed the Cam and Crankshaft Sensors????
bank1 is front or rear?
I just finished , jeepers , those plugs are a pain in the brain ! I never
thought it was that important to secure a plug so hard that you almost
break them to get them off. Kinda like my ex-wife. Thanks Greg
Thanks for the vid. I have the P0340 error I believe it said Bank 1. I
tried replacing the one you did first but still stalls when I try to start.
The car run fine otherwise and don’t notice any stuttering. These P0345
and P0340 codes reliable on where the failure might be?
I changed the sensors this AM on a Murano and let me just say, THANKKKKK
YOU for this video. The clips alone would have made it a really really
tough job with extra work if I would have broken them trying to get them
off. I love the video. THANK YOU again Greg for saving me a lot of time and
money. Keep up the good work *2 thumbs up, 5 stars, 10 out 10* LOL
Great video. what are the symptoms of a bad sensor.
Great video.
My murano has died on me a few times when getting to a stop, also kind of
jeks when driving in the freeway, it’s done it a few times.
Scanned it and the P0345 code came up (camshaft position sensor mulfunction)
I think is time to replace the sensors.
Thanks a lot for this video.
sounds like a heck of a saving on that one,good stuff greg
Great video. Thank you
My Murano threw a code today bank 1 CAM sensor, didn’t want to spend more
money so I decided to just replace bank 1 sensor…the Murano is running
fine now…Just wondering would it be okay to clean the bank 2 sensor and
not damage it? thanks
Well done sir ! :)
Not fun if you suffer from big hands syndrome..lol
I’m still scratching at 7 am
your right on the savings over having the dealer fix it. Did an egr valve
assembly on a Dodge pickup last weekend. Total cost 53.00. Dealer wanted
500.00……….tony
Those Nissan electrical connectors sometimes are hard to get off.
Oh man, another battle with the man fought and WON!
Fun stuff…
You could have knocked 5 off your time if you would have just made a small
blood offering. hehe Daytona tomorrow. Hope that goes better than the
superbowl did
still watching! good stuff all of it! Thanks for the videos!
Excellent repair and FAST too. :-)
Like the new trailer!
Love the trailer… Nice repair!!! CJ
Getting it done in a short time under pressure. Great fix Greg.
Good stuff Greg and fast work
there’s the problem your hands are way to big