In this video we show a 4 zone mitsubishi hyperheat ducted/ductless combo and the reasoning behind our design on this particular job
Mitsubishi 4 Zone Ducted/Ductless
90,770
Like
Save
){kind=link}
- Tags:
Ducted/Ductless, Mitsubishi, Zone
- Categories: Mitsubishi
Comments
Comments are disabled for this post.
What’s up with the surgical mask?
Beautiful work looks fantastic and extremely thoughtful
Hope they removed the blow in insulation from that drain pan. Asking for trouble as the drain pan drain line will probably get clogged.
Nice installation. I have a single surge suppressor on my 48k Mitsubishi and I will probably invest in the line reactor combo unit on my next build. Also, the anti vibration stand off is totally necessary. I have had one lift mechanism go out on one of the mxz ceiling cassettes. The ducted air handler combination and classic wall mount air handler is the best configuration for condensate draining IMO.
To anyone watching, these units are Electricity guzzlers! I have two of these running 8 mini splits (4 each), the electricity bill is maybe $100-$200 less than running radiant heat in those rooms except now I owe $30k! Total Bologna and not worth the investment unless you got solar or a new build going on! Get gas instead, much much cheaper!
Finally got it up and running. The only delays we had was because we realized we needed some extra parts (I’ll list that below) https://www.youtube.com/post/UgkxihMYiJNXcHdbH-7ihymsLz61l7jVyb5O . So we have a loft where our current hvac just couldn’t seem to keep cool during the summer. We have been using a window unit since we bought this house over 6 years ago (all the houses in this neighborhood were built in the 80’s and majority of the houses built like ours use a window unit). I hate window units because they are just so noisy and the one we had really only cools one side of the loft. I had contemplated upgrading our current HVAC, but with all the rising prices these days, it would take years before saving up enough to do that. With the advice of my father-in-law (used to run an HVAC business), he recommended we get an inverter instead. We thought we bought everything we needed, but there were just a few other parts we didn’t anticipate needing (which is what caused most of our delay). My friend and father-in-law did all the work to get it installed and running and now we have nice cool air circulating nicely throughout the entire loft. It is very quiet and even the outside unit is much quieter than our main HVAC unit. Saved ourselves thousands getting this.
I stopped watching it since the dude came in with his face diaper.
How is the formaldehyde line set doing? I just had the same white lines at my own house. And I just had Pin hole leaks throughout the whole entire line.
А де металорукав?Через дерев'яні ліги провода повинні прокладання в металорукаві.
What’s with the stupid mask?