Not really a how to but in all mitsubishi model cars with the 4g15 engine from 1996-2003 (i believe it may be even earlier) mirage/colt/lancer etc the signal…
How to install an aftermarket tacho. (Mitsubishi Mirage)
6
Like
Save
')){kind=link}
- Tags:
Aftermarket, Install, Mirage, Mitsubishi, Tacho
- Categories: Mitsubishi
Comments
Write a comment
You must be logged in to post a comment.
I got lancer 98 gli I found the 1 single connector under the wiper motor
blue,black wire do you think this is the RPM signal wire that to be
connected to green wire of the tacho..
Helped a lot mate! Cheers!
there should be enough room in the stock grommet on the right hand side of
the car
it should be the green wire on the back of the tacho and it taps into the
white wire with a blue connector on the firewall underneath the wiper motor
where do i connect the green wire, it tells me that i need to connect it to
the rpm signal wire but i dont know where that is i look at the distributor
to see if i could find it there but i had no luck if you could tell me
where to connect that, that would be awesome
machine thanks mate
ive got a 1993 lancer coupe cc carby engine, ive searched under the thing
that you showed in the video and it doesnt have the blue connector… any
suggestions on where the rpm signal wire is ?
which wire from the tacho did you have to tap into?
Where abouts in the firewall did you drill your hole to wire it into the
cabin?
No worries my life would be so much easier if I had the blue connector but
thanks I think ive found my solution
on the firewall underneath what looks like a window wiper motor there
should be a blue connector taped into the wiring harness with a white wire
coming off the back this is on the passenger side for both right hand drive
and left hand drive
sorry mate but the cc is a different engine the mirage/colt has a 1.5 f/inj
i wouldn’t be able to help you out 🙁