This is a quick demonstration of how I installed a new bash plate for my 2020 Mitsubishi Pajero sport which was purchased from https://www.customoffroad.com.au
I was recommended this plate from the guys at ‘can’t fault it 4×4’ on Instagram.
The plates are an easy swap over, only requiring a ratchet spanner with a 12mm and a 13mm socket.
Total time should be under an hour.
I hope this how to video helps in some way. Let me know your thoughts.
Leave your questions, recommendations or comments in the comment section.
For all my links including Instagram, tool recommendations and discount codes, click below.
https://linktr.ee/Addictedtotools
#pajerosport
#4×4
#bashplate
#4x4diy
Is this 3mm or 4mm thick? Do the plates cover the rear diff as well?
Hi mate. That is STAINLESS OR MILD STEEL BP. Thanks
That was good. Job for Saturday!
Great video mate, I have the same car so good to know it’s an easy job.
First need to replace the factory bash plate mounts on each end of the middle plate as they WILL break, as they always did in the Challenger.
Nice video mate. Informative.
Also, Have you found a compatible bull bar for your Pajero 2020 yet ?
Look better than OME. Now lets go scratch them up.
Nice video mate … from IG