Mercury Outboard Cylinder Resleeving

Mercury Outboard Cylinder Resleeving

In this video I replace a factory press fit cylinder sleeve in a 1989 Mercury outboard engine. This is not your normal sleeve install.

Click here to watch the video
4,059
Like
Save


Comments

Glynn J says:
November 5, 2022 at 10:16 pm

I’ve welded the inside of races to get them out of a hub. I wonder if that would work for the sleeve?

tyler caulder says:
November 5, 2022 at 10:28 pm

Did you have to bore the sleeves for new pistons?

Comments are disabled for this post.