How To Install Replace AC Heater Fan Blower Motor Ford Escape Mercury Mariner 01-07 1AAuto.com

How To Install Replace AC Heater Fan Blower Motor Ford Escape Mercury Mariner 01-07 1AAuto.com

http://www.1aauto.com/1A/BlowerMotor/Ford/Escape/1AHCX00179 1A Auto shows you how to repair, install, fix, change or replace a broken, weak, noisy or screech…

8
Like
Save


Comments

1aauto says:

You may want to check the antifreeze level in the radiator, and also the thermostat to see if it’s okay. 1aauto.com 888-844-3393

elchikinarco3438 says:

not sure wats wrong with my heater it does not get warm just replaced heatercore but sitll wont warm up wat else could it be ?

1aauto says:

Usually when you loose the fan speeds it’s the sign of a bad blower motor resistor. I’d troubleshoot that first, the AC issue may be a separate issue. You may want to make sure that the compressor is kicking on and off when the switch is engaged. 1aauto.com 888-844-3393

rangipawa says:

Hey there… Our fan is NOT working on 1,2 and 3 with the AC light on. In position 4, fan is blasting away BUT NO AC!!
Would swapping the fan solve this?

1aauto says:

We’ll keep this request in mind in the event that we need to make this repair in the future. 1aauto.com 888-844-3393

frost381 says:

Can you do a vid for an 08 with Nav! , and a video on removing and installing the full climate system behind the center stack in the dash…?

1aauto says:

If it’s a vacuum controlled system, you may want to check the vacuum lines to see if any of them are cracked and need to be replaced. 1aauto.com 888-844-3393

Hugo Núñez says:

hi, i heave a cuestion the blower vent doesnt work, what can it be?? thanks
the defrost works perfect, but the front vent doesnt

1aauto says:

That would be the blower motor resistor. At the begining of this video we show you how to remove it. We sell new blower motor resistors for your Ford Escape on our website 1aauto.com. 888-844-3393

Keith Schrader says:

Thank you so much for your video. Something is caught in the fan on my Escape and it’s making lots of noise. Now I see how to get to it.

Write a comment