replacing an outboard water pump and impeller on a 1998 mercury 25hp 2 stroke outboard engine.
USA
pump kit (OEM) seen in this video
http://amzn.to/2teSs3p
or
http://amzn.to/2sJH5is
Canada
http://amzn.to/2sZ1sqJ
2 stroke mercury 25hp installing a new outboard water pump, impeller and coldstart
12,451
Like
Save
){kind=link}
Comments
Write a comment
You must be logged in to post a comment.
Excellent video ! Thanks
Thanks for the tip on removing the clip for the shift linkage! I was puzzled by this until I saw the video. BTW, my engine is a 9.9 Belgian 2 stroke.
I'm having a hard time getting the lower unit to line back up right! i was wondering if you had any suggestions? thanks
Thanks for the video… Excellent! Would someone be able to recommend where I might be able to get an owner's manual and/or service manual for a 2002 Mercury 25 HP 2 stroke? BTW… Where is the model number and serial number displayed on the outboard? Thanks for your help!
Best video for this subject I have seen. Thanks for helping me out! You missed your calling. You should make instructional videos for other things. Thanks again
Great video…very thorough and detailed.
Great video. Question: I noted that the water from the "tell-tale" was not a stream, but rather a spitting volume. Does the volume of water from the tell-tale increase when the motor warms up, or is this all that comes out?
Great video! Very informative and detailed. Thanks.
very informative thanks.
this install is Water Tight! great vid