Easy DIY how to: replacing headlight bulbs on a Mazda 2 (AKA Demio) (2nd generation “DY”) 2002-2007. This is an easy job with simple access.
This car uses H4 bulbs which combine low and high beams into the one bulb on each side.
You will need:
* New bulbs as required: 2 x H4 / 9003 (replace in pairs) – Amazon US: http://amzn.to/2aFFek1 | UK: http://amzn.to/2crDpbt
* Latex gloves (ideally)
* Flashlight.
(Using the above Amazon links will help support my channel and is appreciated!)
Amazon links to relevant products are in the description.
So helpful for me. Thx !!!!
The plug is hard to remove, afraid to break it
Thank you for this! Both my headlights were dead and I just fixed them myself – definitely see where lady hands are an advantage.
Hahaha. You're a fraud. You chose the easy side. Other side has much less room and needs the bumper removed if you don't have tiny hands.
I just changed the bulbs on my GFs mazda 2. This vid was helpful. Thanks for posting. I had no luck getting the plug off the back initially. What I ended up doing, was just pulling the rubber boot back enough to reach in, undo the spring clip and pull the entire connected plug/boot/bulb assembly out. Then I had plenty of leverage on the plug and disconnect.
Changed in less than 5min. My first car bulb in my life. Very good tutorial. Thx bro.
Thanks done this on Mazda 2 before ,but it's nice to know before doing it again (the left side is harder with the fuse box in the way (2012 NA left side steering) if you look at Mazda manual they want you to take half the car apart .
Vaxes and kills young employees
You should probably mention that if you let go of the lamp whilst attempting to position it, it can fall inside the enclosure – which presents you with a whole new problem 😉
Can't get the plug off
Thankyou , saved me !
I can't even get the bonnet open
Thank you, i have just changed my bulb following your tutorial.really simple.
Thx your Help me nice video:)
Is there a video for brake light bulb same car?
Thanks a lot. Great voice!!
Thanks just did it found it difficult enough,no room but all working.
The most important, and hardest to figure out, is the removing the spring clip.The video does not show this at all, basically worthless instruction video.