This install video shows how to remove the 8mm/Phillips screw holding on the bumper of a Mazdaspeed 3 / Mazda 3. This screw is located behind the fender line…
Removing The Mazda / Mazda 3 / Mazdaspeed Front Bumper
11
Like
Save
){kind=link}
Comments
Write a comment
You must be logged in to post a comment.
Just like he showed you + 2 phillip screws on top of the radiator support,
two bolts 10mm on bottom plastic skid plate and eight more phillip screws
along the bottom. Install, start with side clips, these can be a real pain
in the @#@#@ if you use the ones you can get on ebay, factory ones hold
alot better.
i guess this is the rear bumper? could you do a front bumper video?
That is the front. He said “fender liner” and the title states front
bumper. That’s just loosening the bumper for side access, there is more to
remove at the top of the bumper under the hood, and some screws running
along the bottom as well.
That’s all there is to it!
that’ s it???
I’m pretty sure there is more than two screws holding the front bumper in
place. Please finish this video! This title is very misleading!
How bout the rest of the bumper? Ya jackass