New refurb caliper in and now installing. Bleed the system with a Motive pump, but test drive seem to show more air needs to come out since it was leaking fo…
Mazda 6 Rear Brake caliper installation
8
Like
Save
){kind=link}
Comments
Write a comment
You must be logged in to post a comment.
Your very welcome, have safe Holiday!!
Hi, look at the piston you have to turn the end of it to the right looking
at the piston. Its like a screw, you have to keep turning it until its
bottom out. Its a pain, their is a tool to do this..first time I did it, I
used a c clamp and got it to turn. Good Luck!! Brutmaster08
awsome tripod at 2:05 .. good vid i was hoping to see a rebuild of a
caliper .. mine is stuck fully pushed out .. and wont go back in .. idk why
Happy holidays !!
yea i read the manual which said to turn and apply pressure .. turning it
clockwise didnt do much so i tried anti clock wise and got the piston out
but even if i put it back in it never went lower then one specific area…
thanks for the help .. chears