How to Replace Alternator 07-12 Mazda 6

How to Replace Alternator 07-12 Mazda 6

Stuff I used in today’s video…

Starter: https://amzn.to/2XCM0iZ
Milwaukee Ratchet: https://amzn.to/2Fzf839
Regular Ratchet: https://amzn.to/2FxYsZO
Milwukee Impact: https://amzn.to/2X5c5W2
Socket Set: https://amzn.to/2IOTERA
Socket Extension: https://amzn.to/2XxCIaI
Floor Jack: https://amzn.to/2LmGM7d
Jack Stands: https://amzn.to/2XwcDbX
Wheel Chock: https://amzn.to/2J6Sjog

In today’s video I’m showing you how to remove and install an alternator into a 2011 Mazda 6. This tutorial works on model years 2007-2012.

Click here to watch the video
8,611
Like
Save


Comments

mauro serna says:
November 13, 2020 at 2:18 pm

hello I hope you can help me, the alternator of my mazda 6 2007 was damaged so I got another one, the problem is that the damaged alternator has 3 pin and the one I got only brings 2, what can I do? Thank you

Benjamin Ordódy says:
November 13, 2020 at 2:48 pm

Hey!

Thanks!
It looks rly helpful

But i have an urgent question.

Suppousdly i have a same problem, my alternator does not charge the battery. Wihle the engine was running the alternator charges 11.87 volts which obviously means that alternator is dead.

Before anyting i tried to check the alternator by a multimeter to make sure there is no any charge. I looked for the positive terminal of the alternator. I rly did nothing serious job but my car doest not crank and start since then.

Do you have any idea what could cause it?

I will try to bypass the positive wire to the starter. If it still not cranks could it be one of the ground wires?

I rly appreciate your help

Thanks
Benjamin

Comments are disabled for this post.