A full wiring guide and how to install the Mazda 3 LED Reflectors on the rear bumper! These LED’s shine bright for reverse and brake, and look great as the reflectors on the Mazda 3.
Thank You For Watching!
► Subscribe: https://goo.gl/pKiz53
► Follow Me!
– Instagram: https://goo.gl/SfsiGA
– TikTok: https://bit.ly/3SLGPZC
– Twitter: https://goo.gl/qGEQFe
– Facebook: https://goo.gl/qHnGGz
– Twitch: https://goo.gl/fDCA9A
Hope You Enjoyed!
00:00 Introduction
03:42 Where to Run Wires
05:33 LED Wire Indication
06:33 Where to Connect Wires
09:45 Review
){kind=link}
You've come along way from your throttle body ground with the wiring. My 3 got illegally crushed but still enjoy you vids and your 3 is looking clean. Can't wait to see the trunk, I fiberglassed mine but that was the only way to fit the 2 12s and still have a trunk.
I would have used weatherpack connectors. Has a gasket and easier to disconnect all at once.
Where did you get the lights from plz as you don't ha e a link
I think it depends on what tail lights you’ve got. If they’re clear, go with clear ones. If they’re tinted, go with smoked. If they’re red, go with red ones. I had tinted clear ones on my 2nd gen up until recently, and with tinted tail lights it looked beautiful, but sadly my car was recently defected for tinted tail lights (apparently they’re illegal in Australia). Once I sort that out, I’m thinking of going with red tail lights with red LED reflectors to go with it.
Lights or ok but let's talk about the wiring and lighting in this video.
Love the content keep it up bro!