I need this timing belt installed with proper tension, timing correct. The new belt is already on as you can see, but it’s not tensioned. The hydraulic tensi…
1994 Mazda MPV timing belt replacement, 6 cylinder DOHC 3.0
7
Like
Save
){kind=link}
Comments
Write a comment
You must be logged in to post a comment.
@paulhunter123 dude get over it, that is history, and i have a 1995 mazda
mpv as much as a i love classic american muscle cars the mazda was my dads
and i need to fix it and use it
you might need to buy a new tensioner and line up with timing marks. buy a
hanyes manual.
on the right cylinder head i can turn three times around and its suppose to
line up on the marks but it lands at 11 clock but now i turn the leftside
and it lands right on the mark and destributer i can point to # 1 and runs
rough and missfires and i got the #1 cylinder up tdc please let me know
what to do about right cam and the destributer and send me some good pic.
of where the destibuter and cam is suppose to be thank u very much
you have to take the hydro tensioner out under the lower pulley, compress
it with a vise or c clamp until the holes in it meet,stick a pin to hold it
down, put it back, line the marks and pull the pin.I dont know how you
managed to break the pulley bolt in there because its not suppose to thread
into the hole it just slides in.
your tensioner is defective. you have to grind some off of the brass
bushings so that the bolt that holds it ddown does not squeeze the
tensioner its self. After tightening this bolt the tensioner must pivot
freely. email me your phone number and I will call you. my email is
t8085579058 at yahoo.com
When you get it runnin, make a vid rippin thru some mud ! Its 4×4 right?
my 96 Madza MPV has broken timing belt. Do you know how to put cylinder one
back to Top Dead Center? thanks. I’m changing the belt right now
also i see something weird with the tensioner pulley you sure you got the
richt parts? send me a message to my youtube acount i cans send you
instructions and images from mitchel on demand they will help a lot
replacing the timing belt one these truck is easy
why do americans buy so much japanese junk. pearl harbour! for gods sake.
What haapppend to this did u fix it or what?
yeah i know what u mean, im always fixing my dad old BMW. If it was mine id
prob have sold it.
thats a single overhead cam a dual overhead cam engine on a V-6 has 4 cams
hey i got mitchell on demand i could send you instructions hot to do the
timing belt on this mpv a friend already replaced a timing belt in one of
these trucks and it was easy
Good..t
Nope it’s still sitting there. I’ve had too much to do to fix it,
especially without some help. I did get some advice on pre-tensioning that
I will use if/when I get back to it.
Man I wish I was nearby I’d lend you a hand. I love these mpv’s its been
five months I just KNOW you’ve gotten it fixed by now
are you sure its a DOHC im pretty sure is a SOHC
i have the round distributor cap and i have put the plugs the way it is in
the book and it doesnt work. do you know where the plugs go in the cap