IF YOU HAVE TO TRY AND TURN THE CAR ON 5-10 TIMES BEFORE IT STARTS THAT
MEANS YOU’RE NOT GETTING ANY PRESSURE TO THE INJECTORS, WHICH MEANS YOU
NEED TO REPLACE YOUR FUEL PUMP.
Hi thank you very much for this video your and angel! All you guys out
there mostly all fords have a sistem that when the csr crashes the gas pump
stops working , and some times this sistem gets triger by closing doors or
trunk to hard
how can you tell if the fuel pump is bad? I have to turn the key 5-10 times
before it will eventually start. Then, after 10 to 20 seconds it stops
running. Please help. Need to get to work tomorrow haha
Good job on showing where it’s located but I was expecting a walk thru on
removing the pump. Stating what tools will be needed which way to turn the
ring (clockwise or counterclockwise) and estimated time this job takes. I’m
in the process of replacing mines now and I’m having a little trouble kinda
looking for help in here.
Man I wish I could remember which tools I used once I twisted that top off.
But I believe most of it was a matter of just disconnecting things. I wish
I would have recorded this as I was doing it.
){kind=link}
IF YOU HAVE TO TRY AND TURN THE CAR ON 5-10 TIMES BEFORE IT STARTS THAT
MEANS YOU’RE NOT GETTING ANY PRESSURE TO THE INJECTORS, WHICH MEANS YOU
NEED TO REPLACE YOUR FUEL PUMP.
Glad to help
very helpful thanx
Hi thank you very much for this video your and angel! All you guys out
there mostly all fords have a sistem that when the csr crashes the gas pump
stops working , and some times this sistem gets triger by closing doors or
trunk to hard
Glad to help
how can you tell if the fuel pump is bad? I have to turn the key 5-10 times
before it will eventually start. Then, after 10 to 20 seconds it stops
running. Please help. Need to get to work tomorrow haha
Good job dude. I’m havin’ some problems with starting. Not sure if it’s the
fuel pump yet. Investigation made. Thanks.
Good job on showing where it’s located but I was expecting a walk thru on
removing the pump. Stating what tools will be needed which way to turn the
ring (clockwise or counterclockwise) and estimated time this job takes. I’m
in the process of replacing mines now and I’m having a little trouble kinda
looking for help in here.
Sorry about the camera. I still have to figure this cell phone camera out.
It’s only allowing me to take narrow videos. This is a v6
I had it tested at a shop
Man I wish I could remember which tools I used once I twisted that top off.
But I believe most of it was a matter of just disconnecting things. I wish
I would have recorded this as I was doing it.