Remove your lamp. Unscrew the HID bulb. Cut the wires from bulb back to ballast. Unplug ballast and cut the plug wires at the ballast. Connect the yellow to red and the gray to black. Crimp connectors on the loose ends. Put the 9006 bulbs into the light socket. Stack 4 washers and reuse the 3 screws. Position the led ears, on the black section of bulb body, under the washers. Tighten down until snug. Plug the yellow plug into the positive pin. Then reinstall your light assembly. There will be no error codes and you will be free from buying old HID bulbs at a premium.
What about other headlight with the box over it
These are projector headlight housings from the factory, right? So glare wouldn’t be an issue?
Thank you for making this and for the super clear instructions, you just saved me a lot of headache.
Good to know it drops right in. Thanks for posting