Here’s a DIY on how to replace a lower ball joint on a Toyota, Scion or Lexus vehicle. It can be done with hand tools but an impact wrench makes the job a lot easier. The only special tool…
Here’s a DIY on how to replace a lower ball joint on a Toyota, Scion or Lexus vehicle. It can be done with hand tools but an impact wrench makes the job a lot easier. The only special tool…
You must be logged in to post a comment.
){kind=link}
+speeedkar99 Can you please do a DIY on how to replace a cv boots on a 2003
toyota camry v6. Cause I saw oil coming out from the boots.
Thank you. Good video. Very helpfull.
No anti-seize on the ball joint taper. That should be clean and dry.
Put anti-seize on the axle splines.
once again your shit is the shit! (*_*)
Yea… ball joints suck to replace but worth it in the end when the job is
done.
I’m doing a 1991 Camry and my GearWrench universal ball joint separator is
too narrow! I’m going to see if the OTC separator is wider.
Your shit is the shit dude. Thanks!
amigos en vez del dremel y esmeril esa tuerca se puede sacar con una llave
inglesa o llave de tubo XD
would this be the same process for a 2001 lexus is300?
Thanks for making this video, the one piece of advice though I would give
is I would not put anti-seize on the ball joint bolts. In fact, I think
you should put Loctite on them. I believe that’s why they came with a
small packet of thread locker.
The last thing you want are those bolts coming out.
Can you make a video, regarding the popping sound.. Thanks and advance.
I usually buy sealed items, I dont have a grease gun and seems the
other side was sealed.
I am noticing during your videos you use WD-40 to loosen rusty nuts. You
call WD-40 a penetrating oil. WD-40 is a lubricating oil and not a
penetrating oil. WD-40 with help loosen rusty nuts but it is not as good
as a penetrating oil such as ‘Liquid Wrench’ or ‘PB Blaster’.
Great video and keep the videos coming. I will stay subscribed on your
channel until I sell my Solara.
good evening, and great video, I have a Toyota Camry 02, my steering column
is making a popping sound whenever I may a left or right turn. Please
help?