On this video I show you the basic way of how to remove a rack and pinion in a 2007bnb Lexus rx350 thanks for watching
i am not liable for anything that happens or occurs while you are working on your vehicle, this video is only for a educational tool, and you may need more information to properly do the work. I am not liable for any injuries or death due to your work on your done at your own risk
check out th facebook
https://www.facebook.com/Fixergood351w/
If off centered and wasn’t aligned right with the steering wheel, does the alignment shop adjust and corrects this or they only adjust the toe and camber?
You didn’t have any issues from the steering angle sensor? Before the alignment?
Did you use a impact to get off the mounting bolts
Would this procedure also apply to a 2004 Highlander?
lots of steps were not shown here. watch more videos before you start the job yourself
Thanks handsome ❤️
Hey I’m having trouble reinstalling the steering knuckle to the rack any suggestions?
helpful Thanks. Very hard to hear you though
Hi, I need to replace the rack on my 2008 Lexus 350 ES, is the same as RX?
After changing the rack and pinion the VSC light will come on after driving down the road about half a mile. To reset pull the negative off the battery terminal for a few minutes. However, after doing so passenger window control from the driver's seat will also need to be reset. To reset go to each passenger window and work the windows a few times fully opening and closing. Control should be regained from drivers side window control. Hope this helps someone.
I cant fet the bolts to take fhe rack off t