Removing the cylinder liners/sleeves on a 2003 4.6L V8 Bosch engine. Used a propane-powered torch to heat the block and then a punch and ball-peen hammer to …
Land Rover V8 Liner Removal – Part 2
3
Like
Save
){kind=link}
Comments
Write a comment
You must be logged in to post a comment.
Did you happen to measure the bore size for the liners or the liner wall
thickness? I ask as I’ve bought some top hat liners with an OD of 98.42 mm
(wall thickness of 2.21 mm) and someone suggested to me that these are too
small for the OEM bore.