These are step-by-step instructions on how to install an HID Kit. This video covers what to check for when you receive your HID Kit, how to properly disconne…
How to Install an HID Kit from Beginning to End
792
Like
Save
){kind=link}
- Tags:
BEGINNING, From, Install
- Categories: Lamborghini
Comments
Write a comment
You must be logged in to post a comment.
awesome video. was that buzzing at the end from the lights though?
Thanks man. It helped me figure out the use of the spade connection
cable…v
Congrats! Now you are the cheap ghetto trash that puts a HID bulb in a
halogen housing. Thank you for being one of the tools that blind me at
night.
I think you are missing the units that give the light high output power and
they go between the light bulbs and the ballast! Without them, you will
have a low range light throw.
so there is no need to unplug the negative side of the battery so you don’t
screw up the computer? thank you
I did everything on the video but my damn light won’t turn on!!!!
What would be the color if there’s no ballast installed? Will it still
light on or won’t work at all?
Very nice HID set you are demonstrating with!
excuse me, i am quite confused that, you only wired to the car battery for
the power right? but how to you control to turn off and on HID? did I miss
something from video?
Very helpful. Thank you!
Excellent instructional video. No needless chit chat. No having to jump
ahead 3 minutes of watching someone tighten screws or other pointless waste
of time. Audio is clear and uncluttered by background noise. Thanks!
So just to confirm this, you would need to install a ballast on each side
for each headlight?
I’d put on some dielectric grease before slapping on that electrical tape
Steps looks so easy I thought it would be hard but I can’t wait til I get
my kit thanks for the video 🙂
Mounting the brackets is easier than I thought I thought u had to drill
them in.. also you dont have to disconnect battery before plugging up
ballast?
I was about to purchase the kit and you lost me when you used electrical
tape, that connection should of been a plug if the kit was made properly.
I also have the H11’s and i am stuck at the 4:57 part. Seems my spades
won’t just slide into it’s appropriate place.. I have a 2005 Chevy Malibu..
Any suggestion??
Hi I installed brand new HIDs they work fine for 5/10 minutes then they
both go out, when I turn the lights off and on they come back on, why is
this can anyone help please? Thanks
How did you mount the block? And where inside side panel?
First step is to NOT buy a cheap kit.
Do you know where I can find eagle eye installation instructions for an 04
325i? The zenons don’t work and only the brights work….
how about the balast, is it need to aply 1 blast to 1 bulb or two bulb???
How did you mount the block? And where inside side panel?
spray pam in the socket then fill with wires in place with hot glue it will
form and make a nice male socket
is there a relay in there?
hopefully you used proper projector headlight’s and not your factory
composite ones. if you have them in your factory housings your blinding
everyone
i like your voice
Ya he didnt replace houseing so now this dumbass is blinding people
no
@JustAStoner204 adjusted the assemblies, and the high beam is attached to
the hid bulb and for whatever reason its halogen??
Lol. That’s great.
No, the cables only connect to the wires that were already plugged in to
the stock headlight
very helpful thanks!
Because it seems to me that you don’t hook both of the ballasts up to the
battery.
thanksss
@3DEMENTES Depends on your vehicle,I didnt have to on my jeep but i did on
my dodge ram
Nice and simple…..