DIY lambo door kit installation, Step by step is what we are showing how to do in this video. This is a 2 part video for a DIY lambo door kit installation with a step by step walk through. So many have seen or even heard of the Lambo door kits on the market. In this particular video we show how the Lambo door kit adjustments work what it looks like to install a lambo door kit and for you DIY installation guys and gals, this video will show and share the details involved with how to DIY lambo door kit installation step by step.
DIY lambo door kit installations are not as difficult as it may seem. With the proper tools and the help and advice of this video you will be able to confidently install your own Lambo door kit.
LINK TO THE PRODUCT used in this video:
Camaro ( 2016-18) https://amzn.to/36upHVe
Camaro (2010-15) https://amzn.to/3ilN7ig
Challenger (2009-16) https://amzn.to/3N2FuLV
0:00 intro
5:09 Door kit adjustments
14:00 Door about to go up
When I put a Lambo doors on a 2015 Chevrolet Camaro and I'm going to need a wire harness
Hello, how much does the installation cost in a 2009 Toyota Corolla and a 2014 Mustang?
Where ur shop located?
Who do you recommend for lambo door installation in the Dallas area? I have a 2018 Canaro ZL1.
Wondering if you also do installs??
Do you have a video where you take the Camaro fenders off to install vertical doors without speeding up video?
you should develop a harness extension. would make it that much easier and customer friendly to install.
Will the kit work on Australian built ford territory
Cheers John
Lindo carro
Hello sir can we use only single voice coil of the dual voice coil subwoofer / can we connect one voice coil to one ch and another voice coil to another channel
Hello sir I am having a 2 jbl svc subwoffer of 4 ohms 300 rms and sony 4 channel amp wich has a (70w x4 at 4 ohm ) (85w x4 at 2 ohm) at bridge mode it give (175×2 at 4 ohm ) and another amp which is cerwin vega which is mono amp its rating is 150×1 at 4 ohm and 250×1 at 2 ohm plzz tell me which above amp can i use to get a good sound
Sir why some speaker has same rms output and different ohms for example a (speaker rated 80 rms output 4 ohms ) and another (speaker rated 80 rms output 2 ohms) why the rms out put is same but the ohms is diffrent plss clear my doubt
Sir small dout if am having a 2 svc subwoofer of 4 ohms each sub of 300 rms if i do the series wiering wat will be the rms out put of the subwoffer and wat will be the rms if wiered in prallel plzz help
Hello sir i am having infinty 12’’ subwoffer kappa 500 rms watts having a switch for 2 ohms and 4 ohms load adjustment I am having small dout sir if I put the switch in 4 ohms load will watts will be 500 and if I put the switch to 2 ohms load the watts will be 1000 is this true sir plzzz help me to clear my dout
Nice!! Where did your customer get that rear louver I haven't seen one like that
Back at it again!!!