Parts linked in the description below!
Watch a full tutorial as a Jeep Wrangler Unlimited will have a new pair of NVX 6.5″ Speakers installed. We will be using the NVX VSP65KIT 6.5″ component set. We will show how to install the mid range speaker in the lower dash, and tweeter in the upper dash factory location.
Click here to see the amplifier and subwoofer install video:
https://youtu.be/aACoU2kPRSA
For the radio install, click here:
https://youtu.be/J3lHdwFJHlc
For the rear tower speaker install, click here:
https://youtu.be/B10rv_GJsHQ
This video applies to Jeep Wrangler models for years 2007, 2008, 2013, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017, and 2018. This video also includes removal, wiring, complete installation, and testing.
If you have any questions, leave a comment below! Be sure to like and subscribe!
Parts used in this install (Amazon Associate Paid Links):
*NVX VSP65KIT 6.5″ Component Speakers: https://amzn.to/3qnxv13
https://www.nvx.com/v-series-6-1-2-2-way-component-speaker-system/
*Exact Fit Tweeter Speaker Adapter for 2″ cutout: https://amzn.to/3x0hS25
*Disclosure: As an Amazon Associate I earn from qualifying purchases*
Parts linked in the description!
I actually used this video to get at my recirculating actuator that was broke. Once the speaker is out of the way, it was east work to replace it. Thanks!
Do U have to run crossover with stock tweeter? Also what speakers are you using and what’s price
what are the original speakers
WHAT IS THE HOLE SIZE THERE? I AM CURRENTLY BUILDING A FULL SYSTEM IN MY 2016 JKU AND I BOUGHT KICKER 6.5" 2 WAY SPEAKERS. IT SEEMS THE SOUNDBAR I NEEDED ADAPTERS TO INSTALL THE SPEAKERS I BOUGHT BECAUSE THEY DID NOT HAVE THE LONG EARS LIKE THE FACTORY ONES. I AM ASSUMING THE HOLE IS TOO BIG FOR STANDARD 6.5"
WILL I NEED A SECONS PAIR OF THE ADAPTER RINGS FOR THE DASH OR NO? IT DIDNT APPEAR YOU DID.
You did the easy said you should’ve did the driver side much harder
What did you do with the old tweeter wires?
The tweeter bracket holes are off center, If you turned the bracket 180 degrees would the screws fit in the correct holes?
Do you not plug in the factory wiring any where that was plugged into the tweeter to begin with? In other words, is the only input into the crossover coming from the mid range speakers wiring? Basically, after the new install, the original tweeter wires are left unplugged right?
Thanks!
How many inches of the stock speaker?
Wanted to see the Driver's side install as well. Good video for the passenger side.
No mass loading of the box? No polyfil? Does the increased midbass not "pop" in those boxes? My stock system pops regularly…I am about to upgrade and am worried about that. Stock Jeep audio components are the worst of the worst
Great Video! I finally got this Sub/Tweeter Kit installed and your Video was extremely helpful. These Speakers are a huge improvement compared to the Factory Speakers. I may also upgrade my Soundbar with the exact same Sub/Tweeter Kit.
What about the driver side install?
Do you use self tapping screws?
Thnx! Why a crossover?? What's its purpose??
This is a helpful video, but what you don't show is just how much of a bitch it is to get the driver's side speaker box out. No glove compartment hole to go thru on that side!
Great video mate, definitely a good upgrade