Headlight replacement (2004 Ascender)

Headlight replacement (2004 Ascender)

How to replace the low-beam headlight on a 2004 Isuzu Ascender.

1
Like
Save


Comments

GooberSB says:

Since this video I’ve had to replace the other headlamp and a headlamp
wiring connector. The original connector melted and the charred plastic
caused the headlight to go out intermittently. I had to buy a set of
headlamp connectors and replace the original. Just cut the old one off and
use wire nuts to connect the new one – keeping polarity right.

GooberSB says:

Sorry I didn’t reply yesterday. I didn’t want to type a reply on my phone
and forgot about it later. A magnetic screw driver is best for the small
screws that hold the bulb cover in place since the screws are vertical.

Hector says:

Ah I figured it out. Extremely simple. I dont know why I didn’t figure it
out sooner. Thanks for this video again.

Hector says:

I’m assuming the 05 model should be identical to this. Will try tomorrow.
Thanks. Also, you wouldn’t happen to know how to remove the licence plate
bulbs? I know it’s a simple twist and pull but how do I get in there?

GooberSB says:

You’re welcome. Unfortunately I didn’t have such a video to watch when I
replaced the left headlamp a few weeks before and it took me a lot longer
since I had to figure it all out by myself. Now that there is one I don’t
need it anymore 🙂

Jeff McAndrew says:

Thank you for making this video. Makes the job fast and easy!

Write a comment