What’s up guys? Just bought this rear diffuser off amazon for $80, wanted to give it a shot. Here’s the install and review, thanks for watching and please comment, like and subscribe!
#Infiniti #q50
Amazon rear diffuser link:
Music used in this video –
Tritan – Hollow Life (feat. Ratfoot) [NCS Release]:
Cadmium X Paul Flint – A Stranger’s Dead [NCS Release]:
Update: For anyone considering buying this diffuser – please note fitment isn't too great in the corners and after a few months the molding tape will start to gap out/come off a little towards the top of the diffuser. It is a very cheap diffuser, mine is still on after a couple months but I am going to more than likely buy another diffuser later down the road. Would I recommend this to a friend? Probably not if you can afford to go with the actual Stillen brand diffuser this one is a copy of, or unless you are willing to screw down top side of the diffuser with your own screws.
Thanks for watching guys! Have fun with your Q50 builds!
I installed mine but didnt use nuts and bolts.. might use some tomorrow just to keep it on the safe side. . I only used screws. Might not have been smart on my part
Die Fuser lol
To anyone reading these comments, DO NOT listen to these guys and Don’t put SCREWS IN THE TOP OF YOUR BUMPER. 1. Buy a urethane diffuser for $30 dollars more and not the abs version. Use real 3m tape, not the preinstalled tape from China. . 2. Scuff the diffuser before applying the tape then use isopropyl alcohol to clean bumper. Then apply adhesion promoter to the area where the tape will touch the car. 3. Heat both then apply with solid pressure. It will hold just fine.
Maybe if you heated the ABS it would have conformed to the bumper in those corners.
nice 🙂 btw. what means the "a" next to Q50? Never seen this 😀
Has it held up?i just got mine today
Hey guys, looks like the link off Amazon is currently unavailable. If you still want to try this cheap diffuser out here's pretty much the same one for the same price off Amazon. Thanks for the watch guys and have fun 🙂
https://www.amazon.com/dp/B076CT4YCH/ref=dp_cerb_3
What do you recommend for closing the gaps?
How is it holding up so far?
good idea, with the heat gun !!! i don't mind to bolt my bumper too but i don't how it will last without screws upper side .
thanks sharing your experience !!!!
Looks good,unfortunately the 3m tape isn’t going to hold. Not today,not tomorrow but it’s going to separate eventually. I didn’t want too but I put screws in it. I found the smallest black screws I could find and put 3 on along the top. You can only notice when your really up close