just a quick vid did most of the steps having a hard time finding clutch fork help me out well pretty sure i found it just un sure about removal, took 3 or 4…
Removing a standard transmission out of fwd hyundai tiburon, and possiby help me!
4
Like
Save
){kind=link}
Comments
Write a comment
You must be logged in to post a comment.
Inside the clutch mechanism and therefore allowing you to remove the clutch
housing from the engine further then the few inches that you have. The
throw out bearing can also be removed but it is difficult. There is a snap
ring on the inside edge which needs to be spread out apart to allow the
throw out bearing to slide off. I have removed these and used them again
without incident.recommended is a new one though.
watch?feature=endscreen&v=-yfICJKkLhE&NR=1 Excellent video on You tube
another one on the gears watch?feature=endscreen&v=-yfICJKkLhE&NR=1
Just as the other posters said. You must remove the clutch fork lever
located in front of the clam shaped shift fork towards the front of the car
on the transmission housing. This fork is held in place by the throw out
bearing which is subsequently held with a spring clip onto the clutch
plate. Remove the 12 mm bolt on the clutch fork and lift the keyed fork off
its mount and it now allows the shift fork to release off of the throw out
bearing.
remove the clutch lever and you will be able to pull it out
Thanks for the comments I did figure it out forgot to comment