This video is for 2013+ Hyundai Genesis Coupe owners looking to modify their grille to a higher airflow and easier to accessorize version. Our pre-cut and pre-bent mesh piece that is used for the mod and available for purchase in the link below.
Please note that some owners have experienced difficulties re-installing the bumper after mesh install; and in some circumstances the mesh needs to be pushed forward to clear the crash bar for bumper re-installation.
————————————————————————–
🌐 Buy The Mesh Piece Here 🌐
https://www.customcargrills.com/proddetail.asp?prod=Hyun-Gen-C-13
————————————————————————–
ADD US ON:
Instagram ⭐ https://www.instagram.com/customcargrills
YouTube ⭐ https://www.youtube.com/subscription_center?add_user=customcargrills
Facebook ⭐ https://www.facebook.com/customcargrills
iOS app ⭐ https://www.appstore.com/customcargrills
————————————————————————–
DISCLAIMER:
Due to factors beyond the control of customcargrills llc, we cannot guarantee against improper use or unauthorized modifications of this information. customcargrills llc assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use the information within this video at your own risk. customcargrills llc recommends safe practices when working on or around vehicles and or with tools seen or implied in this video. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these parts, tools, equipment, or from the information contained in this video is the sole responsibility of the user and not customcargrills llc.
————————————————————————–
Thank you for watching and supporting our small business.
#customcargrills #hyundaigenesiscoupe #customgrill
){kind=link}
My bumper is very difficult to put back on after installing the grille mesh. What do i need to do?
Did y’all figure out fitment because I bought one put it on now it’s till tilting up from the bottom
I followed all the steps and when I try to mount bumper onto the car it doesn’t do all the way in due to the crash bar being in the way, is that supposed to happen(
Anyone know the part number
I really want this but the grill is back ordered. Do you guys know when the grills will be stocked again ??
Can I slap the bumper on 12 hours after putting glue?
i have 2015 mazda 3 and my grille measurements is 36" x 36" and i cant find a mesh sheet that fits my grille, where can i get it?
Would look better with the center "bar" left in. Looks like poop without it.
Ok so the 'uncomfortable cut' for me was not the center bar, but the top portion of the grill as it is connected with the top bumper connection piece. So cut the top grill carefully so you do not damage the top of the bumper section. After sweating 5 buckets of sweat from that cut, I used several dowels in both top/bottom and side to side to pull the grill into the bumper form which is not flat. The toothpick trick is perfect…little blob…dab to bumper…repeat many times, 2x around the edge to ensure it was all covered nicely. The little project came out really nicely and took overall about 3-4 hours of work and 2.5 days cure time for the goop.
A tu un vidéo comme il on faite le support en tuyau rond
Number plate can still be installed after this right?