Excellent video! I had to replace a handle and bracket yesterday just like in the video. Both the lock and latch rods will snap into place after the bracket is installed wit the hefp of a screwdriver and perhaps a needle nose through the round hole in the side. I put a dab of lithuim grease on the new door latch rod retained to make it easier to push the rod into place.
It appears that the door panel does not have to come off to replace the exterior handle, just remove the bolt behind the plug. Am I correct? This is a very good video!
Also like the hood emblem wrap, can the look tumbler come out without removing the handle- possible to remove without breaking things/ I don't have any new parts. Thanks for the video now I know what to expect.
){kind=link}
Excellent video! I had to replace a handle and bracket yesterday just like in the video. Both the lock and latch rods will snap into place after the bracket is installed wit the hefp of a screwdriver and perhaps a needle nose through the round hole in the side. I put a dab of lithuim grease on the new door latch rod retained to make it easier to push the rod into place.
It appears that the door panel does not have to come off to replace the exterior handle, just remove the bolt behind the plug. Am I correct? This is a very good video!
Did you fix the issue to kept the door open?
Also like the hood emblem wrap, can the look tumbler come out without removing the handle- possible to remove without breaking things/ I don't have any new parts. Thanks for the video now I know what to expect.
I badly need that hood decal, any links?