http://www.1aauto.com/1A/WiperMotors/Honda/Accord/1AWWS00011 1A Auto shows you the steps for installing or replacing a bent stripped or broken wiper arm. Thi…
http://www.1aauto.com/1A/WiperMotors/Honda/Accord/1AWWS00011 1A Auto shows you the steps for installing or replacing a bent stripped or broken wiper arm. Thi…
You must be logged in to post a comment.
i just tried the replace, and the wipers were no-responsive… the rotating
unit within the engine compartment is working fine, is it possible that the
nut may need to be on tighter?
just turn the key off when in the upright postion do the nuts then get them
in the right postion this worked for me
@tnskda1 Usually (on most vehicles) there’s a little tab that you pull out
under the wiper arm where it attaches to the stud. Pull that tab out, and
you should be able to lift up on the wiper arm, removing it from the stud.
We currently do not have an auto repair video that shows you this
procedure. However under the metal arm where it attaches to the stud, there
should be a small metal tab on the arm to pull out, that will allow you to
remove it. Hope this helps you out. 1aauto.com 888-844-3393
You should be able to just line them up on the bottom of the windshield.
thanks
You could try that, you may want to check the linkage to see if anything
could possibly be stripped, causing it not to move.
I might have to play around with them a little bit and see how they perform.
how do I replace a wiper arm 1996 chrysler concord LX
How do I make sure my wiper arms are in the correct position when I put
them back on? I recently replaced my wiper arms on my 1990 Honda CRX (they
were missing).
I need help replacing a wiper arm on a 2000 mercury grand marquis and video
or suggestions would be highly appreciate it I can’t find anything online
for replacing on my car.