In this video I show you how to change out your headlight bulbs in your 96-00 Honda civic. To see my video on how to remove the headlight assembly, click on …
In this video I show you how to change out your headlight bulbs in your 96-00 Honda civic. To see my video on how to remove the headlight assembly, click on …
You must be logged in to post a comment.
){kind=link}
Ahhh man, i saw fucking shit.
You shake that camera allot ! :)
thanks for the great video!
That little spring clip that holds the bulb down is a pain in the dick. The
passenger side was fine but the driver side keeps springing back out as
soon as I press the connector into the bulb. Maybe it’s damaged or
something. I’ve cursed at this thing A LOT.
Thanks, but can you hold the camera more still.
What camera are you using???
For the corner light DONT DISASSEMBLE EVERYTHING!!! There’s a little screw
that attaches the bumper to the fender remove it, pull thebumper down like
an inch and move the mud guard to the side a bit there you can access it
🙂
Thank you!!! I just couldn’t see how the catch was attached because it was
the driver’s side and I didn’t think to look at the passenger side for
reference 😛 Now I changed my light and I feel like a winner!
Thanks for your site and help. I just changed a bulb with your directions
and taking a screen shot of the retainer clip position with my iphone.Great
close-ups in your video.
Thanks for posting.
Well you sure get to the point! Headlamp! No messing about like the guy
with the Red 93 Civic! He removes the whole headlamp and then the blinker
assembly just to change the headlamp bulbs?! So great job! Had a go at
changing my last bulb: difficult, as not good with my right hand just now
but still got the job done! I checked in here to see how you guys do it &
remind myself If I got the right fitting for my Civic and these new Xenon
bulbs. Hope they last as I don’t want to repeat this!
Its about damn time I found a video that shows how to do it right.
The passenger side is a cinch even if you don’t remove the air filter. The
driver’s side is the hard one since there is very little room even once you
remove the power steering fluid reservoir and you are working blind. An
let’w be honest, the lock-down wire holding the bulb is a real PITA!
thanks for the video. changed the headlights on my ladys civic 2000 cx. way
too crowded in that thing. thank god im on the smaller side because my dad
and brother could not get their hands in there. that spring/pin holding the
light in place took me about 10-15 minutes to put back in place because of
how warped it was. none the less, the video was helpful. watched it once
and went to work. many thanks.
Got a 98 this is a great vid , but i cant seem to get the rubber seal off.
am i just not pulling hard enough? do i pull at the rubber or teh wires?
thanks
Also, the owner’s manual describes how to remove the old one, but doesn’t
discuss installing the new one at all. I was hung up on how to position the
spring – once I saw how you left it completely open I was able to complete
my installation. THANK YOU!
I wanted to let you know that this helped me. I have a 2009 Toyota, not a
Honda. The headlight looks just like mine though. Your video provided an
unobstructed view of the process. Under my hood the battery impedes with
the driver’s side headlight, and the windshield washer container impedes
with the other.
Thanks for making that so easy…only took a couple minutes..
Thank you so much! It took me an hour to change the bulb last year because
I could not figure out from the instructions in the owner’s manual how to
remove the metal clip that holds the bulb in place. Now it’s time for me to
change the bulb again. I’ll let you know how it goes this time.
UNREAL. Time to change the easier one on my own, looking at it and thinking
the best way to start would be to unscrew the retaining screw on the
clamp…then forgetting which way it went on? 4 hours. Time to do the 2nd
one after watching your video? 15 minutes.
Well is sounds like you got it done though, so that’s good right lol
thanks, this was very helpful, unfortunately it didn’t solve my problem,
and now I want to punch the guy who sold me this car.
Thanks for the video!! Helped me a lot!!! 🙂
I can’t get the piece at 00:22 to come off. its stuck on there. how do i
get it off i’m pulling and its just jammed on there.
lol nice
thank you thank you thank you!!! that bulb stumped me. totally. thanks dude.
Your welcome, I’m glad I saved ya the extra work.
both of my lights are missing that clip thing ( 00:29 ) do you know where i
can find this piece ?
thanks man
@skaterboy520c thanks that will help others
No problem
Thanks, Very Usefull.
Ebay, or a junkyard.
thanks 🙂
Dude you rock!
No problem thanks
today i was changing bulbs on my honda , One side was easy but on another
one connector was stuck. I cant disconnect it from bulb.. i dunno what to
do now. I was so pissed..