This is by far the most complete video I’ve seen online about changing the
brakes. Everything you said went right in line with what I just did to my
front brakes – thank you for such a great video! Adding this to my brake
changing notes!
i am not a mechanic at all, but do my own brakes. i never would use a flat
head screwdriver to depress the calipers. i been using a Brake Caliper
Tool Spreader
){kind=link}
This is by far the most complete video I’ve seen online about changing the
brakes. Everything you said went right in line with what I just did to my
front brakes – thank you for such a great video! Adding this to my brake
changing notes!
i am not a mechanic at all, but do my own brakes. i never would use a flat
head screwdriver to depress the calipers. i been using a Brake Caliper
Tool Spreader
Share:
Did u have to leave the brake fluid cap off under the hood to take off the
breaks ?
I never turn rotors anymore. Takes too much time and new rotors aren’t that
expensive. I also find they warp out quicker after you cut them.
Once they are heat checked like that they don’t cut well. The rears were
original and too thin…
I guess that you ruled out getting the rotor turned?
Usually… Since the new front rotors have the screw holes I didn’t feel it
was worth the effort.
Good video.
Nice video. Do i have to pinch or bleed the brakes?
Yes you are right I should use them (I have four pairs). Thanks for the
watch and the comment!
C00L
Jack stand JACK STAND
do you put anti seize around the middle where the rotor sits, I find that
it make life easy in future
Good stuff Carl.
Cool