2013 2014 2015 Honda Accord Parking Light Fuse Replacement

2013 2014 2015 Honda Accord Parking Light Fuse Replacement

If your parking light is out.. check the parking light fuse. The fuse is located inside of the car on the driver side fuse panel.

15
Like
Save


Comments

salmanslim says:

sorry to bother u again, have u used any wifi or bluetooth obd2 devices
with this car ? i am looking in amazon they have both Bluetooth and wifi
but i am not sure if it will work on this new honda .

Luke Schmidt says:

Thanks for the video. I installed high-powered LEDs in my ’15 Coupe
projectors, as well as LED reverse lights. Everything was fine for the
first few days. Now, all of a sudden, my parking light fuse keeps blowing.
Any ideas? 

salmanslim says:

Hey do u know if I can use obd2 scanner on this car?

Shazib Iqbal says:

I want to wire footwell LEDs. I have seen your video on the footwell led
install but I’m not to savvy on electrical work. Can I use the DRL fuse
with an add-a-circuit to get power for the LED system?

Steven Tran says:

So I did the switch replacement, my tail light work now but my parking
strip still does not work, could it be because the wires are touching
something or is the parking strip messed up?

simon tsoi says:

THANK YOU BRO , I had this problem last time . Honda jewed me $ 400 .

i KNOW how to fix this time

rickpaty123 says:

Just curious, for what reason does the fuse blow? My rear lights are not
working so I’m about to go check it. I did replace the parking strip bulb
to led but that was two months ago.

pete jimenez says:

Ah ok maybe this will help me… i have installed HID’s for my low beams
and fog lights the passenger fog light stays on for about 8 seconds after i
turn on the car then goes off i have replaced the HID kit twice & i know
for sures its not the KIT but the car its self maybe just that fuse i will
try it. 

kobe Kobelly says:

Hey, my hazard light stop working. I changed my fues that’s located under
the hood but still not working and note that my left and right signals are
still working. Thanks

Chris Nguyen says:

Do you know where can I look up for the Reverse Light fuse ?

Write a comment