I show how to remove and install the front Spindles on a GMC Sierra 1500. This is the same procedure if your are installing lowering or lifting Spindles. It’s also the same for a Chevy Silverado as well. This should be the same procedure for 2005-2013 model Chevy/GMC 1500 2wd. Hope this helps. Thanks for watching! Don’t forget to Subscribe.
If i have a 3” leveling kit on a 2008 silverado (the spacers between the springs) with stock suspension…will installing 3” spindles raise it any higher im looking for a solution for this not to happen the control arms are maxed out and was wondering if 3” spindles will remove the tension off them since it will attatch at a higher level then stock spindles?
Can I use stock spindles from Tahoe and put It on a gmc single cab?
do u need new upper control arms with a spindle lift?
What size was the Allen key on the bottom ball joint
Did you have to install a extended brake lines for the lift spindles? I'm planning on getting 3inch lift spindles and not sure if I will have to order extended brake lines as well. Thanks
Where can I get the lift spindles for my 05 GMC Yukon
You did a great job good work and thank you for showing how u did it all
Good stuff.
when going from stock to lift spindles, do you have to replace stuff like the tie rod or the shocks?
Did you need brake line extension for the 3 in lift spindle
My upper control arm is stuck and I cant get it out. I've tried banging on it as hard as I could and still nothing. I'm trying to install a lift spindle and the shops want to much money. I'll try this technique tomorrow and see if it helps. Thanks for the helpful video!
Only one tip for this post. Never hit the studs with a hammer. That's why hes having issues with the nuts threading back on. Other than that he's doing okay.
18:19 did you forget to tighten the third hub bolt?
any advice for the spindle being stuck on the lower control arm? everything is loose except the bottom and this has turned into as of now as a 3 day process maybe 4 and I just can't break it loose, and i,ve beat the hell out of it. thanks.
Did you have to get an alignment after