https://www.1aauto.com/accelerator-pedal-and-position-sensor-general-motors-25832864/i/gmfac00002?utm_source=YouTube&utm_medium=description&utm_campaign=videodesc&utm_term=2NMvPgWWdSc
1A Auto shows you how to remove, install, fix, change or replace a broken gas, throttle, accelerator pedal and position sensor. This video is applicable to the 07, 08, 09, 10, 11, 12, 13 Chevy Silverado and Tahoe, and GMC Sierra and Yukon
🔧 Instructions:
1. Disconnecting the Battery 1:11
2. Removing the Accelerator Pedal 1:32
3. Installing the Accelerator Pedal 2:35
⚠ DISCLAIMER:
While 1A Auto strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
){kind=link}
good video but how do I know when to replace it what code should I be getting? I have a 2004 avalanche and it's got the check engine light. all help I appreciate it
so what if I have auto adjust pedals???? HOW DOES THE CABLE COME OFF????????????
The process look cut and dry. I had the local GMC parts guy tell me it had to be programed by the dealer. True or not? I'm replacing it on a 09 GMC Serria.
Pretty sure my truck (08 sierra denali) needs this replaced. It just stopped working temporarily awhile back and worked again for months but it reoccured. This problem is extremely dangerous because my truck literally had no power while on the road. It does flash the other abs/traction problems when it happens. Some roads have no place to pull over so it can be a huge problem.
I watched the video and it seems pretty straight forward. As I have been reading posts about this same process, others state you need to delete any codes which might exist and be sure to reset the idle back to factory settings. I have a 2003 GMC Yukon XL with what I believe has issues related to needing a gas pedal sensor or TPS replacement. Would I need to follow those steps or simply replace the pedal sensor?
Could that be a reason why the car has no power
I have a 2003 gmc sierra 1500 5.3, is the process the same ?
Whats the process on a 1980 chevy silverado i have one and does the same process work on my truck can you please help?
thank you very much . nice and good video . thank you again.
About how much are those?