Basic instructions on how to mount a aftermarket mounting kit. Don’t forget to check out my other automotive related videos and subscribe. Thanks for watching!
How To Install A Car Stereo Aftermarket Mounting KIT: GM Example
68
Like
Save
){kind=link}
Comments
Write a comment
You must be logged in to post a comment.
Cool! Sorry for the late reply!
Never mind, bending out the tabs worked fine! 🙂
Hey Johny, I’ve watched a lot of your dirtbike videos, but I never noticed this one. Now I have a problem, though. It’s a radio cage similar to yours, but I do not understand how the tabs will hold it in place. The way they are oriented the look like they would only stop the cage from being inserted more, rather than being pulled out.
Yo may have to fold it in the middle a little and spread it back out once you have it in the kit.
my cage wont fit into the kit
Thanks for watching!
thanks dude i thought that was just a extra peice forgot to clip those
Not sure how to describe it really. The kit instructions have always worked fine for me.
how do i put this kit together the instructions dont make sense
Factory ground is fine.
Found one where the main harness goes into the car.
Same way pretty much. You probably have a larger style radio and they make a double din plate for it.
How can I do this for my 1984 Camaro I-ROC Z28? I never did this before, so I will need some helpful advise before I make a decision and thank you in advance.
You may have a factory installed amp. If so, it will need to be bypassed. A lot of times they make an adapter to bypass it.
Hey I have a jvc aftermarket stereo and I recently installed it an it turns on but there is no sound nor is there static. But the factory radio works and has sound when it plugged in. I have all wires hooked up right but what’s wrong???
Hmm. Sounds to me like a bad radio. It could be a weak ground but I doubt it.
Thanks and have you ever had a problem with you CD player when you turn the ignition and all it does is turn the motor to eject the disk then just turn off and when you hit the display button and only shows the time ad does turn complete on
I think anything made after the mid 90’s is the same but I could be wrong. I know the older cars are a bit different but not sure about the latest (last 3 years).
Do all gm model cars need that same wiring harness or are the model specific
Best Buy or Crutchfield I believe.
Were did you purchase this kit mount stereo……the black Face
Just snaps together.
how do you put together the kit?!?
I suppose you can do that. The cage just locks it in.
what if i installed but did not put the cage…. its cause it was really tight so i just left it out
I would try Crutchfield (online). They carry the best of them.
I just got a 89 tans am with the same radio and main question is where did u buy the adapter because I see one in bestbuy but the wires arent colorful it looks like the left side of ur daughters adapter please help I just got this car for my birthday please respond
Usually they come with a little set of forks to pop out the radio. You can get a small screwdriver and slide it between the sides of the radio and the cage and try to get it out that way.
How do you pop-out the stereo from the cage after everything has been installed in the car? I need to remove my heater control unit, and I can’t remove the screws holding it in place until I remove the stereo. I can’t seem to get anything in there to undo those clips locking the stereo unit in place.
Yeah, eBay should have them. Just type in “car stereo cage”.
I recently bought a jvc kd-s37 and after watchin your vid I realized that it doesn’t have that “cage”. Can u buy them somewhere ? If so what would I type in to find them ?