Part 1 of 2 of my Driveway Series” of “how to” repair vids. This is my old Chevy Van with a small block GM 350. We tear down the starter and replace the “sta…
Part 1 of 2 of my Driveway Series” of “how to” repair vids. This is my old Chevy Van with a small block GM 350. We tear down the starter and replace the “sta…
You must be logged in to post a comment.
this helped me a lot thanks 😀
how did you took the spring off from gear ???
Hey thanks for the good video. I’m in Portland too. I pulled mine apart to replace the drive this week and was confident about doing it because of your video. Only thing in mine, I did not have any washers/spacers at the brush end of my armature and it does seem to have some lateral play so maybe I will add some shims.
One quick problem. You disconnected the positive, rather than the negative battery cable. Always do the negative first; if your wrench touches a grounded part, you won’t do any arc welding, as would be the case if you were trying to remove the positive cable first.
I think I have another vid where I take apart the solenoid. Take the big nut, 2 small ones and the two screws out. I will try to attach the other vid here.
thank you very much its so useful to me but i had a problem the solenoid couldn’t open it i tried many times i wish advice how i can do it