Replaced the stepper motors in this GM gauge cluster. I forget what model truck its out of. Either a Tahoe or Suburban. The truck has been sitting for a year because the speedo finally stopped moving after the RPM and temp stopped. I replaced them all with a kit I got on Amazon and then I adapter some 5050 Blue LEDs to fit in place of the backlight bulbs. The LED uses a 150ohm resistor for current limiting. my phone was recording in 1080 not 4K Motor Kit www.goo.gl/eTFoq7
I have that exact one , can you do mine for me $
Transmission fluid gage
Thank you for posting this it really helped me figuring out my dash :{)
Awesome video thank you. You make it look so easy but l know it not.
I did all the motors and the LEDS and the lights work but the motors are all off and or not working correctly. My oil pressure needle still dances and I think the sending unit must be the issue. My tac is getting power but doesn't go higher than 1000 rpm
Would doing to much heat cause the guages to not work? I think I messed it up
I appreciate your video but out of all the videos on YouTube I have not found one video that shows details of which light pin is Hot and which is Neg, Thanks.
What size is positive on the circuit board
Yes finally a good tutorial of information much needed.. thanks so much..
Fantastic tutorial. One question, how did you determine the positive post on the circuit board for the led's?
Incredible job producing this video! Best I've watched. I have an H2 SUT 2007 that just had auto start installed and now the speedometer light and the three light to the right are out. All lights to the left still work fine. Can't say the installer did it as I didn't notice for a couple of days. Thanks for the great instruction. Where does one get the LEDs for this?
Can you do mind and how much your charges Hummer H2 2003