There’s NO doubt 351 Windsor blocks are tough as nails. Found one for $300 that had a hole in the side. Will it EVER run again?
#ford #mustang #foxbody #neomustangs #horsepower #builtnotbought #diy #howto #351w #408stroker #install #engine #enginebuild #mechanics #fabrication #budget #junkyard #351windsor #smallblockford #strokermotor
Scrap bro buy one at junk yard
Wrong somwtines rod bolts vibrate and back offand you find them in the pan
408w it is my man
It probably spun the bearing. The bottom of the bore looks like a notch for a stroker. The rings do not go down that far. My 351w from the junkyard had a similar failure and the machine shop was able to bore the block. He had to line hone it though as the main cap fit loose on the second main.
Since its a cheap fix, save it(especially if it's a roller block). No sense in spending more time and money pulling another block if you don't have to.
It's a Ford in the junk. Should have left it where it belongs
Interernal combustion engine. Not a "motor".
Can you still use this broken 351w????
Love the Fox Body content.
FIX IT AND SEND IT!
Ford 351 Clevland or Windsor both make perfect boat anchors