This is on a ford 9 inch , but can be appled to many different rear ends. Jeeps have the same procedures as well. I cover how to remove a pressed in axle bearing, how to remove a bearing race from an axle tube. how to use a slap slide hammer. how to press in bearings on an axle. CE-8015
Check out my channel for automotive how to videos:
How to install a megashifter on a thirdgen camaro/firebird:
https://www.youtube.com/watch?v=lhcg1alo_ao
How to install a holley stealth ram:
https://www.youtube.com/watch?v=S6n2D5bp1VA
How to install a vintage air system:
https://www.youtube.com/watch?v=4JtAOyAAEhs
How to Convert from a mechanical cooling fan to an electric fan:
https://www.youtube.com/watch?v=ItnDr6GNV44
How to make steel braided lines:
https://www.youtube.com/watch?v=3agSiujdbnw
How To Bleed Brakes:
https://www.youtube.com/watch?v=f57r4lqxTC4
How To change Brake Drum Shoes:
https://www.youtube.com/watch?v=mYekEpon244
follow me on facebook:
https://www.facebook.com/klowny1969/
follow me on instagram:
https://www.instagram.com/klowny1969/
Follow me on twitter:
https://twitter.com/klowny1969_
How to install a dakota digital dash:
https://www.youtube.com/edit?video_id=-QJYpXe1jGc
thirdgen klowny1969
){kind=link}
Is it normal when you assemble a brand new rear together to have little bit of gear oil leak past the seals? I have a curry housing with a 31 spline set up all brand new and I was told to install it with a gallon of gear oil. Sitting on jackstands a little bit of gear oil drips out of the seals. Why is that if everything is new thanks for your help
Thanks man! I like the way you explain things. It makes sense when you say it haha
8:59 ICE CREAM TRUCK
good job on instructioning. Thanks.
Is the penny width critical on new axles and bearings? I pressed mine on until the bearing reached the shoulder. Is this going to be a problem?
Hi, I have a 12 ton HF press. Things pressed on a little then locked up. Plenty of lube oil. Think 12 tons is enough? Bending the table. Argh!
nice dude. love the channel!
Would synthetic grease be better than gear oil?
Cool man. Should I drain the 9in box before pulling these out? Or does that matter.
Use a little lube, a little butter sauce. Lol. Good video Manny! You always make your vids easy to understand and follow.
Cool, I have an 84 Z28 I bought new. My old 7 inch Chevy diff sings a little at 45 mph. Wish they had put a stronger unit there.
Can't wait for another video!
please keep making Camaro videos
Clowny how long you been working on cars
Are you still using the stock style suspension? I'm getting ready to build a 9" for my 83 camaro.
aye bro u got a email address or fb i can hyu on
Slide the shaft into the hole….oh yea baby!!
I love your videos!!!
Slime hammers and rear end lube. 'Nuf said.
Another job well done. Haha did you hear the ice cream truck. HAHA