Buy Now!
New Control Arm with Ball Joint from 1AAuto.com http://1aau.to/ia/1ASLF00246
1A Auto shows you how to repair, install, fix, change or replace loose, worn, or control arms. This video is applicable to the 05, 06, 07, 08, 09, 10, 11, 12, Ford Escape
🔧 List of tools used:
• Pry Bar http://1aau.to/oc8/1AXAA00020
• 13mm Wrench http://1aau.to/ogn/1AXAA00010
• 13mm Socket http://1aau.to/oA4/1AXAA00015
• 15mm Socket http://1aau.to/oA4/1AXAA00015
• 21mm Socket http://1aau.to/ohV/1AXAA00043
• Center Punch http://1aau.to/oaH/1AXAA00055
• Floor Jack http://1aau.to/oiB/1AXAA00068
• Hammer http://1aau.to/oe4/1AXAA00091
• Jack Stands http://1aau.to/oiB/1AXAA00065
For More Info visit us at http://1aau.to/h/byo/
⚠ DISCLAIMER:
While 1A Auto strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
√ Watch the Video
√ Buy The Part at 1A Auto http://1aau.to/m/Visit-1AAuto
√ Do it Yourself
√ Save Money
Very simple and didn't take super long! Btw my CV axle overextended but I moved the steering wheel a little and rotated the wheel hub and pushed in until it went back into place. No problem 😉
Just called and ordered the new control arms from you guys after watching your video.
Awsome rite to the point in detail good teacher
One side down. I didn’t need to use a punch on passenger side. And I believe nut was in back not in front.
If we have space is it better to torque again once vehicle is lowered
Hey just wanna give a thumbs up to Andy for being an outstanding teacher!! Watching him do these jobs has given me the confidence to go where I have not gone before. Coincidentally this video and the ones he did for front & rear brakes on Nissan Versa takes care of both of our cars!! Thanks for taking the time guys! – Rick
Is it only possible to replace the lower control arm, when the lower ball joints has slack?
what size pickle fork did you use?
How can you tell that part is bad
How do i replace the bushing for the control arm on a 2013 Ford escape