Shop for New Auto Parts at 1AAuto.com http://1aau.to/c/63/W/fog-light-assemblies
1A Auto Shows you how to install, repair, fix, change, or replace a broken, damaged, burned out, cracked, faded, cloudy or chipped fog light. This video is applicable to 06, 07, 08, 09, 10 Ford Explorer
🔧 List of tools used:
• 10mm Socket http://1aau.to/oFg/1AXAA00017
• 8mm Socket http://1aau.to/oFg/1AXAA00017
• Ratchet http://1aau.to/oUE/1AXAA00016
• Socket Extensions http://1aau.to/oKg/1AXAA00015
For More Info visit us at http://1aau.to/h/aAT/
⚠ DISCLAIMER:
While 1A Auto strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
){kind=link}
√ Watch the Video
√ Buy The Part at 1A Auto http://1aau.to/m/Visit-1AAuto
√ Do it Yourself
√ Save Money
I used a 1/2 inch deep well 3/8 drive work great
Excellent. Thank you
you forget turn on the lights…
My tabs were brittle. Screwdriver broke the tabs on one side. On the other I used needle nose pliers to compress one tab at a time and wiggle the pins through. Nothing broke, came right out. Raise your hand if yours has a plastic pin sticking out that prevents the bulbs from turning far enough to be removed and you were a breath away from cutting it off before you realized you just needed to remove the wires. Guilty lol
I used a slightly differently method. I used a 13mm socket(deep) to push in the little tabs that hold it in place while using a plastic pry tool from the front to pop out each corner. Was pretty quick and didn't have to get underneath the truck to push in the tabs.
The video was helpful to see what I was up against. I could not get the plastic cups to go in so I could get the fog light assembly out. What I did was to take a pair of tin snips and snip off the round black part where the clips where at. Just clip off all three round plastic parts and the fog light pops right out. The new one popped in with no problem.
What is the bulb model number for the 2007 Ford Explorer Eddie Bauer?
This is h13 lights??
Thanks for easy directions. Ordered from you all and will give this a try!
Does this same fog light assembly fit into the bumper of the 2006-2010 Mercury Mountaineer?
Thanks for this. It was exactly what I needed.
Just What I Needed! Thanks.
Is this the same size for 2006 Mercury Mountainer?