Buy Now!
New EGR Pressure Feedback Sensor (DPFE) from 1AAuto.com http://1aau.to/ib/1AZMX00048
In the video, 1A Auto shows how to remove and replace a broken or failing input speed sensor. The video is applicable to the 00, 01, 02 Ford Focus
🔧 List of tools used:
• Flat Blade Screwdriver http://1aau.to/oP3/1AXAA00013
• Gloves http://1aau.to/oca/1AXSS00048
• Pick http://1aau.to/oey/1AXAA00037
For More Info visit us at http://1aau.to/h/bIh/
⚠ DISCLAIMER:
While 1A Auto strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
){kind=link}
√ Watch the Video
√ Buy The Part at 1A Auto http://1aau.to/m/Visit-1AAuto
√ Do it Yourself
√ Save Money
The dpfe on my 2002 focus mounts the same way. but it looks like the mounted type without the bolt holes, with the oblong connector. I can’t use the cheaper part because their connections aren’t the same. What was Ford thinking?
I would suggest using a mini needle-nose plier to remove the piece that broke off in the rubber tube. Also, DO NOT use PB Blaster on rubber tubing unless you don't mind destroying the rubber. Use 100% silicone. You can also use o-ring grease like commonly used in swimming pool pumps. Other lubricants can react with and "eat" rubber.
I replaced this on my 2002 mustang (v6) and it wouldn’t start afterwards, so I had to put the old one back on, but I still have the check engine light. Any tips?
Where is this part located on a '02 Duratec DOHC 3.0LTaurus ?
I've got a 2003 ford taurus; on the back side of the engine there's a part that has melted, and it being messed up makes the exhaust very loud; there are two holes where the hoses go in, and it sucks air, if I put my finger on the holes the exhaust gets quiet; what is this part called…?? Help!!
That egr valve looks a bit rusty.
No diagnosis???
Would a 2017 Mazda CX 5 be too new to do any simple videos on? Thanks.