Repairing a dodge 8.4 U – Connect Touch Screen Part # X0036TAOCH Glass Digitizer WU1062 8.4 yourself and save money 💰#digitizer#dodge #touchscreen
Repairing a dodge 8.4 U – Connect Touch Screen Part # X0036TAOCH Glass Digitizer WU1062 8.4 yourself and save money 💰#digitizer#dodge #touchscreen
Comments are disabled for this post.
Hey just replaced my digitizer put everything back in the car how it was and now my bluetooth and car play connect but no sound any word of advice
Pulled the black wire off accidentally. Any suggestions or am i screwed
Or you could spend a little over 200 and have one shipped from China. That is an upgraded part number.
I just bought a new screen for 200 online lol.
Hello,quick question. I replaced the whole unit. I connected the ribbons & installed it without all the screws on the back to make surenit worked b4 i put it all together. Now i took itback out put all the screws in and its saying no signal found? What do youthink happened?
For a digitizer that does not come with adhesive, what kind of adhesive is recommended? I have seen another video of this repair where Gorilla Mounting Tape (double sided) was used to adhere the digitizer to the screen, but I also see electronic repair tape online that is super thin and is used for replacing tablet and phone screens. The mounting tape is a lot thicker. Is there any benefit to one over the other?
I did this job yesterday, I used 91% isopropyl alcohol and Gorilla tape…I also ordered a new screen. this job is not easy and my hat goes off to BJ..
So if my screen is ghosting I basically need to take it apart and clean it throughly??
I brought a replacement screen put it all together it didn’t work properly so I clean the one that I took off originally I used a magic eraser to get screen clean and clear put it all back together and boom works like new just clean all the glue off both screen use some double side tape and it might work for you like it did me no more ghosting try before you buy a replacement digitizer
that little wire from the black metal frame is a ground, which makes the touch screen work via electrical conductivity via your finger.
My 2018 Dodge Durango has multi colored lines going from top to bottom, started with one, now there’s a bunch. The touchscreen works fine, will this fix that issue or do I need to replace something else?
Is it ok to use some of the cleaner to get the glue off of the ribbon cable at the bottom of the screen?
Hey bro I cleaned it and everything but the touch won’t work no more any way you can help me ??
Where are u located bro?
I cant find the 4.3 size ..