How to Replace Brake Light Switch 2002-2008 Dodge Ram 1500

How to Replace Brake Light Switch 2002-2008 Dodge Ram 1500

Buy Now!
New Brake Light Switch from 1AAuto.com http://1aau.to/ia/1AZMX00026

This video shows you how to install a new brake light switch in your 2002-2008 Dodge Ram 1500. The brake light switch is a sensor or switch that is connected to your vehicle’s brake pedal. It is the switch that is responsible for turning on brake lights. It is a very important piece of equipment. If the switch in your vehicle has failed, replace it as soon as possible with a quality direct fit part from TRQ.

This process should be similar on the following vehicles:
2002 Dodge Ram 1500
2003 Dodge Ram 1500
2004 Dodge Ram 1500
2005 Dodge Ram 1500
2006 Dodge Ram 1500
2007 Dodge Ram 1500
2008 Dodge Ram 1500

Tools you will need:
• Flat Blade Screwdriver http://1aau.to/obeA/1AXAA00013
• Pocket Screwdriver

Subscribe: https://www.youtube.com/channel/UCWCdsftsTqYMO7cA_5Sc-yA?sub_confirmation=1

⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

26,725
Like
Save


Comments

@TRQ says:

√ Watch the Video
√ Buy The Part at 1A Auto http://1aau.to/m/Shop-TRQ-Parts
√ Do it Yourself
√ Save Money

@paulpaad9300 says:

You just re-installed the old switch. Can tell that because the adjustment lever is already turned. You neglected that part of the process.

@popeyesh8790 says:

You have to say everything men

@popeyesh8790 says:

It doesn’t need to be adjusted the switch

@arnaudstral says:

Hello,
I have an extra wire for my trailer brake light. Where can I plug it on the connector to send 12v when I press the pedal ?

@williamautore1646 says:

Where’s the spring clip I’m scared I’m gonna break something

@TejasToolMan says:

take the switch apart, sand the tabs. good as new for another 200k miles

@chuckleoni338 says:

You forgot to “move the black adjustment lever clockwise to adjust the switch The lever should be parallel to the connector. After you inserted the switch into the bracket.

@ninadennis5078 says:

I have a 2006 Dodge Ram 3500. The brake light on the dashboard comes on sporadically while driving. Will the replacement of the brake light switch fix that issue?

Comments are disabled for this post.