In this video I show how to replace an upper control arm/ball joint and bushings on a 2003 Dodge Stratus with a 2.4L engine.
In this video I show how to replace an upper control arm/ball joint and bushings on a 2003 Dodge Stratus with a 2.4L engine.
You must be logged in to post a comment.
){kind=link}
What bushing is that? I tried Moog and ruined 3 of them trying to get them
in with the same ball joint press. The rubber would just mush and
eventually tear or go in at the wrong angle and tear. I tried with “a
little” lubricant and “a lot” of lubricant and no luck. Thanks!
hey mike, i been looking for a video on removing the strut and stocks, this
was the nearest to what i am looking, this is best one on a dodge stratus.
thank you thank you thank you
very nice work.very detailed viewing.
I nned to do this on my sebring, will be watching again
Would this work for an 02 Dodge Stratus 2.7L V6?
Thank you.
Hey.i know this video is old but i just replaced struts on 02 sebring is it
a big problem i tightened fork bolts and through bolt without jacking up
control arm i did jack.up n tighten strut nut on top should i be ok? Thanks
yw keep um coming.
my sebring sometimes stalls on hot starts
You made this job easy. Thanks.
great vid…very informative as Im about to do this job on a 98 status.
You are very welcome.
Thank you-thank you-thank you You talked me right through this procedure
Only problem I had was tightening nut on upper ball joint without it
turning Awesome and thorough video
yes it would – just did my 02 ordered upper control arm online – very
reasonable