This video shows how to replace the A/C condenser fan on a Dodge Ram 2500, but can be applied to other model vehicles. This was a complicated repair with unf…
This video shows how to replace the A/C condenser fan on a Dodge Ram 2500, but can be applied to other model vehicles. This was a complicated repair with unf…
You must be logged in to post a comment.
I replaced only fan mtr,$45,,,removed 4 screws holding fan housing ,pryed
open top & removed fan nut with mini ratchet & 2 of the 3 8mm nuts holding
fan mtr on,then from under truck,remopved ,cut,clipped off one of the 17
gaurds off to acces 3rd 8mm nut holding fan mtr in ,that’s it,& installed
new mtr,,,,1hr done,,,,i have pictures ,561-929-2170 Ray,,i do Appliance
repair,Handyman service in Boca raton fl,,I read all comments & didn’t see
easier way,,sooo here it is,thank you &,goodluck
Wow! Thank you very much!!!! you saved me a TON of cash with this video. I
only replaced the fan motor @ $32.00 and I removed the front cross bar
(that latches the hood) It was tricky but non the less. Thanks again!
Great tip on pulling the condenser forward to slide the fan out. Much
easier than removing the battery tray.
Going up above engine gives you lots of room. Little wiggling getting
around fusebox. Had old fan off, new one in and blowing cold air in 25
minutes. I did have someone holding coil and shroud together for me A long
thin screwdriver helps get the screw brackets back into the shroud.
Watching this certainly was a big help.
i have an ’03 dodge 1500 and i have this exact same problem helped a lot
keep it up!
Note – all hardware is in metric. First two big bolts are 13mm and the 4
side bolts are 10mm.
After I replace the replace the A/C condenser and put back the panel, have
I something else to do? Somebody told me about a “Actuator Calibration and
Diagnostic” is that true or just need to recharge A/C?
Glad you benefitted from it.
and i have that exact same cigarette lighter charger haha
Great Job!
Thanks for the video, it really helped.
Just had this happen to me (2003 1500 w/hemi). Exact configuration. My
neighbor & I disassembled from frame & concluded the only way to get around
was to clip out the very notch (upper left side) you did. I also now know
it is all one assembly (Chrysler bastards!). – However, we lifted the coil
UP instead of down. May come back and let all know how that turns out.
Thanks for the verification of our own idea.
you are the greatest, that helped me a lot.
Good vid buddy.
Thank you so much! I did my own repair and saved 375.00! I did the work
without anyone to help except you! Took right at 2 hours, just a little
under. Excellent Video.
What a pain!
How do I replace just the motor?
I did this repair and the video was really helpful. I had to put the shroud
also but it seemed like the only way without draining the Freon. I don’t
have a lot of mechanic experience at all and this was easier to do than
changing the brakes or the alternator. The hardest part of this was getting
the bolt behind the fuse box. I got the whole thing out by myself and put
it back in with the help of someone else to make sure it went smooth. Good
helpful video!!!!!!