2009 Dodge Ram Infinity Amp Bypass/Radio Replacement

2009 Dodge Ram Infinity Amp Bypass/Radio Replacement

How to replace 2009 Dodge Ram radio including bypassing the Infinity Amp behind the glove box.

Wire Schematic list is below my affiliate links. I Hope this helps you!

Please support my channel by shopping for what you need for this project from my links below:

Wire cutters: https://amzn.to/33fF6aB

Wire toner to check speaker wires: https://amzn.to/3eZ6rAj

Wire crimpers: https://amzn.to/3r09EFk

Wire strippers: https://amzn.to/3HPKy2Z

Crimp butt connectors: https://amzn.to/3G8tHYq

Radio Dash Kit: https://amzn.to/3F5gD4M

Radio Harness: https://amzn.to/3f4i60R

Antenna adapter: https://amzn.to/3q4MXk1

16/4 Speaker wire: https://amzn.to/3n1U2ju

Wire Schematic:

Center Dash Speaker: Grey/Orange (+) Grey/Brown ( – )
Front Left Tweeter: Grey/Yellow (+) Grey/Orange ( – )
Front Right Tweeter: Grey/Dk. Grn (+) Grey/Lt. Grn ( – ) (Same colors as Rear Left Door)
Front Left Door: Grn/Yellow (+) Grn/Lt. Blue ( – )
Front Right Door: Grey/Yellow (+) Grey/Lt. Blue ( – )
Rear Left Door: Grey/Dk. Grn (+) Grey/ Lt. Grn ( – ) (Same colors as FR Tweeter)
Rear Right Door: Grn/Grey (+) Grn/Lt. Green ( – )

#DIY #Maintenance #Repair #Cummins #Diesel #Amp bypass #Bypass #Wiring #navigation

16,348
Like
Save


Comments

Wyatt Blackwood says:

Man, I just put a new Kenwood head unit and couldn't get no sound out of any of the speakers and answers on Google were dead ends. I was beating my face off the dash and about ready to have a stroke until I came across your video and it was like the clouds parted and Sun started shining through. Thanks for all your hard work and sharing the information !!!

Scott MaKrae says:

I'm curious how you determined the polarity of the speaker wires going to the speakers? I can tell just by listening to the speakers when music is playing, but other than that would need to connect a dc power source to the wires and then test with a meter at each of the speaker terminals. How did you do it?

Jacob Martin says:

Do you have to use the green box? I did the bypass and everything in my 03, stereo is acoustic as hell and doesn’t get loud, like it honestly sucks, yet same everything except head unit model sounded great in my 07 Chevy.

Pickle says:

They make a harness for this I believe

Jimmy Avalos says:

Can i get the wiring colors

Brain$hot ♪ says:

is there no way to turn on the amp instead of bypassing, i thought i was going crazy when the speakers where not playing sound lmfao

LethalWar says:

not being rude 1st step never EVER cut wires so CLOSE TO FACTORY PLUG !! what if you have to use it again ? Now you have to depin it and connect new pins / with wires. .. just a little FYI. but good tutorial !

FlipSide Garage says:

Do you need to plug it back or can leave the plugs unplugged since no longer needed?

FlipSide Garage says:

Is this the same as a 2011 with alpine system?

David Josey says:

Question I have a 2006 Dodge ram truck with infinity speaker system. I had Best Buy upgrade my stock stereo with a Pioneer now the system will not fade. Best buy said that when you change stereos the Infinity system will not fade.. Is that right?

6NZ Chencho says:

Can I just wire my stereo off the battery with a fuse. And run new speaker wires ?

clasicradiolover says:

Isn't there a wire I could send power through to turn this amp on?

Justin B says:

Well this make all my speakers play instead of how they are set up from the factory where the front door speakers only play bass?

Edward Kehling says:

See I knew I wasnt crazy when I was trying blue to blue white, red to blue, cant tie it in with yellow or it wont turn on lol I do notice that the clip you pulled out was yellow/red, is this why my radio wont work red to red yellow to yellow? Would explain alot lol I have it powered with yellow and red tied up

Alex shalko says:

Hey I have a question, do you have the wiring digram for the radio plugs for the oem navigation system. Someone stole my oem navigation and I got an aftermarket radio. All I need Is just a few pictures of the oem plugs so I can wire mine up. Please and thank you I can pay some $ also

Steve410811 says:

I have a question. I have the same system. Im gonna put a new reciever and new amplifiers. Can i just run. Rca jacks to the both amps and speaker wires to channels on the amp? I dont use the controls on steering wheel.

the real bigfoot says:

Better way and cheaper.
https://youtu.be/ZFl3G4BrVak

Comments are disabled for this post.