In the video, 1A Auto shows how to remove, replace and install an old, rusted, corroded or leaking upper intake manifold. The video is applicable to the 05, 06, 07, 08, 09, 10 Chrysler 300
🔧 List of tools used:
• Flat Blade Screwdriver http://1aau.to/oom/1AXAA00013
• Complete Metric Socket Set http://1aau.to/ocU/1AXAA00043
• Needle nose pliers http://1aau.to/obC/1AXAA00051
• Needle nose pliers http://1aau.to/obC/1AXAA00052
• Slip-Joint Pliers
• Ratchet http://1aau.to/ooq/1AXAA00016
• Socket Extensions http://1aau.to/okH/1AXAA00015
• Torque Wrench http://1aau.to/od3/1AXAA00044
• Complete SAE Wrench Set http://1aau.to/o4/1AXAA00011
• Brake Parts Cleaner
• Gloves http://1aau.to/o8/1AXSS00048
• Paper Towels http://1aau.to/oaZ/1AXSS00035
• Pick http://1aau.to/oa2/1AXAA00037
For More Info visit us at http://1aau.to/h/Gp/
⚠ DISCLAIMER:
While 1A Auto strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
√ Watch the Video
√ Buy The Part at 1A Auto http://1aau.to/m/Visit-1AAuto
√ Do it Yourself
√ Save Money
My mechanic said I need new intake manifold bolts and I can’t seem to find them anywhere. I have the 4 bigger ones but can’t find the 3 smaller ones. Anyone know where to get them
Thanks, you are a lifesaver
This is my car, exact same make and model
Dope
Do you have to replace the intake manifold gasket every time you remove the intake manifold, for example I’m just trying to check my spark plugs, should I have a replacement gasket ready and what if I have to take it apart again a little later.
Got everything replaced new, can’t get the egr tube to line up or stay in place on manifold although everything else lines up fine .
1:34 what is the top sensor called?
I had a problem with the transmission dipstick tube getting in the way. There's a bar mounted behind where the three strut nuts are that I ended up having to take off to get the manifold off. There's 2 13mm bolts on each side and you need to pop some trim off of it.
So you don't tighten it allot? I tightened mine really tight
Please make video on v8 intake
Can you guys do a tutorial on how to put a cold air intake on the Chrysler 300
Makes it look so easy. I cant get mine over the trans dipstick tube
How much for this part ? What is the part number ? Upper Intake Manifold