Car Fix DIY Videos

Buy Now!
New Control Arm from 1AAuto.com http://1aau.to/ib/1ASLF00686

This video shows you how to install new control arms in your 2007-2010 Chrysler Sebring. Control arms are a crucial part of the suspension system of your vehicle. They not only carry the load of the vehicle to the wheel, but they typically also maintain its alignment. Control arms are typically large and strong, so you may be surprised it needs replacing. They contain rubber bushings for smoother rides at the cost of eventual wear. When those bushings run out, that can have a negative impact on the ride and safety of your vehicle.

This process should be similar on the following vehicles:
2007 Chrysler Sebring
2008 Chrysler Sebring
2009 Chrysler Sebring
2010 Chrysler Sebring

Tools you will need:
• Pry Bar http://1aau.to/oa/1AXAA00020
• 24mm Wrench
• 18mm Socket http://1aau.to/oa/1AXAA00043
• 19mm Socket http://1aau.to/oa/1AXAA00043
• 21mm Socket http://1aau.to/oa/1AXAA00043
• 1/2 Inch Air Impact Gun http://1aau.to/oa/1AXAA00252
• Torque Wrench http://1aau.to/oa/1AXAA00044
• Rubber Mallet http://1aau.to/oa/1AXAA00413

Subscribe: https://www.youtube.com/channel/UCWCdsftsTqYMO7cA_5Sc-yA?sub_confirmation=1

⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.