2015 CHRYSLER 300 DONT START, BAD FUEL PUMP, HOW TO REPLACE FUEL PUMP

2015 CHRYSLER 300 DONT START, BAD FUEL PUMP, HOW TO REPLACE FUEL PUMP

Videos are for Knowledge & Entertainment purposes only.
Due to factors beyond the control of RB The Mechanic, it cannot guarantee against unauthorized modifications of this information. RB The Mechanic assumes no liability for property damages or injury incurred as a result of any of the information contained in this video. RB The Mechanic recommends to follow safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, chemicals, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of RB The Mechanic, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not RB The Mechanic.

72,321
Like
Save


Comments

@boom-wu9ux says:

My car was driving fine but at idle waiting for the light it started making that cranking noise and turned off I hope it is just the fuel pump

@romelrodriguez9998 says:

Thank you so much for showing us how to do this bro. Just saved myself $1,350 which is what the dealer quoted me for both pumps. Bought a $70 pump on Rockauto. Ended up just changing the driver side pump and Voila!! It started. Thanks again bro bro.

@romelrodriguez9998 says:

Do you know if the same pump works for both sides???

@thisguyadam5329 says:

Changed my fuel pump gas said it was low put gas in it and it still didn’t start any reason ?

@MrKingVulture says:

Anyway to prevent this?

@user-vg5qb3ju7l says:

I tried what u said but my 2006 Chrysler 300c 5.7L hemi still cutting off while driving

@kingjet7199 says:

So my car wouldn’t crank at all ,changed the starter and then it worked perfect for 2 days then I wake up one morning and it won’t turn over, (mind you everythign was working fine) could this be a camshaft sensor problem becuse it’s popping up on my reader or fuel pump Chrysker 300C5.7 hemi 2013

@davidhindy says:

Shouldnt pressure be released from system or else risk spraying fuel all over place

@leroyking3058 says:

Hi. My test light came on also when I test for 12v and ground..so this means my fuel pump relay is good right??

Comments are disabled for this post.