Shop for New Auto Parts at 1AAuto.com https://www.1aauto.com/*/c/59?utm_source=YouTube&utm_medium=description&utm_campaign=videodesc&utm_term=QLhOl0ZhaOY
In the video, 1A Auto shows how to remove and replace a dented, scratched, corroded, rusted or missing rear bumper. The video is applicable to the 14, 15, 16, 17, 18, 19, Chevy Silverado
🔧 List of tools used:
• Pry Bar http://1aau.to/te4/1AXAA00020
• 15mm Socket http://1aau.to/takn/1AXAA00015
• 18mm Socket http://1aau.to/tse/1AXAA00043
• 22mm Socket http://1aau.to/ta/1AXAA00266
• Ratchet http://1aau.to/taeg/1AXAA00016
• Socket Extensions http://1aau.to/takn/1AXAA00015
• Torque Wrench http://1aau.to/tqM/1AXAA00044
For More Info visit us at http://1aau.to/h/bwx/
⚠ DISCLAIMER:
While 1A Auto strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
){kind=link}
It doesn't seem to answer any questions in the comment section ! I'm taking a leap with this one.
Can a 2010 Silverado trailer plug-in plate changed ? Mine just collapsed last week. The lock-in hole is totally gone (left of the rear license plate) therefore, the trailer connector is just hanging loose. I don't need to change the whole bumper because it is in an excellent shape.
so total of 6 bolts need to come out?
Needed to replace the damaged bumper step pad on my 2016 Silverado. Your vid pretty much spot on with a few exceptions. My truck has the trailer hitch which adds a bit of complexity. Yes, I raised the bed as you described and popped the wiring harness and trailer conn. But I found 5 bolts holding the bumper on. Had to watch your vide 4 times to figure it out. The last bolts are 13mm and sit behind the bumper and tucked up behind the trailer conn and rear tire port. They attach the bumper to the hitch. Also I used a floor jack and 2×2 to raise the bed rear to put a 2×4 block to support the bed. Worked well.
A lot of rust on that truck's frame for not being that old.
How do you get the spare tire trap door off the old bumper??
*6 BOLTS FOR 2015 CREWCABS*
Instead of the ratchet to lose the bolt, I used a 3/8 drive Snap-on battery impact without any placement issues. You can use it for every single bolt.
My fault just answered my own question at minute 2:00
Do I have to remove the hitch completely
I want Know how to install silverado 2014 rear bumper on silverado 2013 .