How to Replace Front Upper Ball Joint 1999-07 Chevy Silverado

How to Replace Front Upper Ball Joint 1999-07 Chevy Silverado

Buy Now!
New Ball Joint from 1AAuto.com http://1aau.to/ia/1ASBJ00117

Modern suspensions combine a number of moving parts for safe and stable handling. The ball joint is the crucial moving component that ties those parts together. The ball-in-socket joint can wear out and loosen over time. Or, the rubber protective boot can tear, allowing contaminants to seize the joint. Bad ball joints are a common failure point on vehicle inspections because they lead to unsafe driving conditions. Fortunately, they are relatively easy to replace with the right know-how. This video shows you how to install new, quality TRQ ball joints on your 1999-2007 Chevy Silverado.

• Check here for more videos on the 1999-2007 Chevy Silverado: http://www.youtube.com/playlist?list=PLJVpHWuCEUX9UxfAHgxfkoYJPq4Q1iy4k

⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

35,755
Like
Save


Comments

TRQ says:

Watch the Video
Buy The Part at 1A Auto http://1aau.to/m/Shop-TRQ-Parts
Do it Yourself
Save Money

alexzf6 says:

Was that truck sitting at the bottom of the ocean?

602santana says:

What size is the upper b joint nut?

Todd Miller says:

good job but why install non greasable.parts

3ad3oyzWin says:

Wow, last time I did mine (same truck) I had to disconnect everything. Axel nut, tie rods etc..so for clarity..(on this model) if only doing the upper joints, all the extra disassembly is not required? Thx in advance

Toe Gobbler says:

What’s a vericle?

Gode utsikter Til lange ansikter says:

No grease fitting to the new balljoint?i have that on mine….2001 chevy tahoe LT Autoride…..

Jonn Miller says:

So My question is, How do I know if my control arms allow the press able ball joints and don't require the whole assembly ? Ive got and 05 Silverado as well

Austin Goleman says:

Dame that truck been at the bottom of the ocean look at the rust

Comments are disabled for this post.